Questions & Answers for: master cd Computers & Internet

...The steps for creating a master are outlined on page 27 of the manual. Setting the in and out points can be found on page 30 and burning the master to CD is on page 67. Hope this helps. Cheers.

...you can increase/decrease volume as needed, so you have a more uniform recording. Masters are burnt slowly to insure they give you a quality master cd. (Always make two master discs, just in

...CD Whne mixing thru the Master Room and buring CDs on my Roland 2400 CD, I can't seem to produce a CD with a volume range near that of standard CDs. Is there a way to set the "output" volume as it ...

...master and 1 CD drive as slave on one IDE channel, with the other 2 CD drives on the other IDE channel, one set to master and one set to slave. So, pull the CD drives out and check the master/slave ...

...Master then the CD drive needs to be jumpered to Slave. If the existing drive is jumpered as Slave then the CD drive needs to be jumpered as Master. Both drives on the same IDE cable cannot be ...

how do you set master slave on this drive On the back of the drive, there is a group of 8 pins grouped in 4 pairs next to the power connector. 3 of these will be marked MA (master or master with slave

...master. For 2 cd's you have to make 2 masters, one for each recording. The best way to handle this is to "create a song" for each speech giver and give each a name.This is because you can make only ...

need jumper settings to make ASUS CD-ROM-S480/ah the master CD -ROM no jumper setting needed it is based on cd rom connectivity wire.......use first block to make it master as it contain to blocks

...master thing and everything sounds perfect . . . until I burn my songs to CD. When listed to on CD players, th Ok, so I have a Tascam 2488 Portastudio. I've recorded my songs, done the whole ...

I can,t get master write and create audio cd . Appear messages no master Why I can't cruet cd and see message no master ? Can you call technology expert