Questions & Answers for: Intel master cd Computers & Internet

Question about DG965WH Motherboard

1 Answer

...BUT IT CAN'T READ It problem with ur cd-rom lense or try another cd if still da problem da same change da cables check jumpers is it set to master or if u sill have problems just buy a new cd

Ad

Question about D915GUX Motherboard

1 Answer

...master can be present so check the other device also. The cd / dvd may also be a smaller SATA drive and in that case you simply need to plugit into a small exactly same type of connector on the ...

Ad

Question about D845GVSR Motherboard

1 Answer

...how to correct it? My PC configuration is given below: 512+256 MB DDR RAM Intel P4 2.8GHz motherboard D845GVSR. you don't want the cd to be master,You want to change boot order and make cd,first

Question about D845GVSR Motherboard

3 Answers

...cd then start the installation good luck There are several possibilities:- !. The Master Boot Record may be corrupt. Insert the Windows recovery disk and select repair. For more advice consult the ...

Question about D845GVSR Motherboard

1 Answer

...should be Master and CD-ROM should be slave. 2) Check the cable of hard disk and CD-ROM. 3) Use different power supply which should be in good condition and than attach your hard disk and

Question about Desktop Board D815EEA2 (BOX815EEAA2) Motherboard

1 Answer

...cd rom. What could be the proble. The dvd is seconday master. hi, Is the hard disk drive is in secondary slave? If yes, change it to master and your dvd is into slave. Refer to the jumper settings at ...

Question about Desktop Board D815EEA2 (BOX815EEAA2) Motherboard

1 Answer

...Master, and so on, thats the case if you have an IDE CD-ROM, if you have Sata then you just need to connect it properly or just check if your Sata has been enabled on your BIOS settings. Also , check ...

Question about Desktop Board D815EEA2 (BOX815EEAA2) Motherboard

1 Answer

...jumper settings for putting them in master and slave mode. just read on the drive label and set your cd rom to master and your hdd to slave and you will be able to boot through cd and instal

Question about (AXXSCD) Internal CD-ROM Drive

1 Answer

...CD-ROM uses. This can either be IDE or SATA. Note that for IDE interface, there is a master/slave/cs settings for the device. If you are using one cable to connect the hard disk and the CDROM,make ...

Question about D850MV Motherboard

1 Answer

...CD drive.One thing that may be causing the problem is if you have just fitted the drive and didn't set the Slave or Master jumper correctly. This will only apply if you have IDE drives of

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...