Questions & Answers for: ASUS master cd Computers & Internet

Question about P5RD1-VM Motherboard

6 Answers

...Master and CD-ROM as Primary Slave & SATA HDD as 3rd Master..IDE Hard Disk and it shows DVD-ROM and CD-ROM same as Primary Master and Primary Slave in the Bios Setup but did not shows any Hard Disk ...

Ad

Question about P5RD1-VM Motherboard

1 Answer

...are trying to say that you have an ATAPI CD-ROM and the Sony CD-RW, then check your master/slave/cable select jumper settings on the device. Each IDE channel can have at most one master and one

Ad

Question about P4V8X-X Motherboard

1 Answer

...master not detected, somebody who can help me solve this problem?? Check your power supply that its working or not. If its working then Please check all the cable inside your system and then try ...

Question about P5S800-VM Motherboard

2 Answers

CD-ROM drive jumper on master. BIOS should detect all drives You also need to assign the boot order in BIOS. CD-ROM should be the first boot device to load and install the new OS onto the primary hard

master and the Cd needs to be set to slave. If they are on separate IDE slots then they both need to be on Master. Try putting them onto separate IDE slots and see if it works. Get a replacement Video

Question about MB P5KPL-CM C2D LGA775 INTELG31 ICH7 DDR2 PCI-EX16 FSB 1600(O.C.) 10 Motherboard

1 Answer

...master and cd rom become primary slave, check after this, and if still get error check your IDE cable, and for the smart command fail may be your HDD didnt support smart feature, so disable this from ...

Question about M2A-VM (0610839149438) Motherboard

1 Answer

...CD to a Master since it will have it's own Channel. Second, try remove all but the New HDD from the system. Set the New HDD up as the only HDD and see if the BIOS will see and allow you to select it. ...

Question about M2A-VM (0610839149438) Motherboard

1 Answer

need jumper settings to make ASUS CD-ROM-S480/ah the master CD -ROM no jumper setting needed it is based on cd rom connectivity wire.......use first block to make it master as it contain to blocks

Question about 22x Internal CDDVD Drive Burner

1 Answer

...Internal CD/DVD Burner is not being recognized. Please help. Look into the little jumpers on the back.If its SATA its np But if its IDE you need to set the jumper to master or slave or cable

...master over write password. You can remove or change the Window’s User or administrator's password. You need access to a computer with Internet access to download the Hiren's Boot CD and burn ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...