will still exist : - Use a laser lens cleaner CD - Open your PC and check whether all connections to CD are OK (flat cable,power cable,Master/Slave jumper). Let me know with your results. Good luck !!
...CD master with a 7 minute pregap BEFORE track one begins. I have Sound Forge 9 and CD Architect 5 which says you can do it. The problem is that the CDR burner ''requires the start time for track 1 to ...
cd rom or hdd. (3). the device has a master /slave jumper that is not set right. (4).the flat ribbon that is connected to the device is not properly connected Ie red strip to pin 1. i would go through
Question about 52x32x52 PX-230A Internal CD-RW Drives - Beige (12-pack) (PX230AIBPS) CD-ROM Drive
...block on the rear of a DVD. by IDE connector. on the case above there will be a Table marked . Master: Slave: CS. Now, you must set the jumper as to your drive's position. IE: Master or Slave, ...
...master cd drive Looks like the original poster has moved on to a new device, but for others experiencing problems with this drive: Go to Plextor.com and download the firmware update. If you have the ...
Question about PX-716A (PX716ASW) DVD±RW Dual Layer Burner
...choose master or master with slave. You need to configure the jumper at the back of the drive as shown in the following picture Configure the CD/DVD drive as slave, configure the hard drive as
...could not be detected successfully when i try and burn a audio cd. try to change or place the jumper sir, jumper pin can found at the back of your dvd, it a small pin that can set the master,slave .
Question about 52X24X52 CD-RW Drive, Model: PX-W5224TA-BPS (E40030) Burner
...cd,press escape then press f10 to save to cmos to restart (note after you have loaded the operating system you must go back and change the first boot device to your hard drive) The BIOS is AMI. Under ...
Usually answered in minutes!
12 Questions
7 Questions
5 Questions
5 Questions
5 Questions
