QMark Heating & Cooling - Recent Questions, Troubleshooting & Support
Why doesn't heater heat up when turned on ?
- I bought 3 convection heater ( model 052-2026 ) .Two of them stop to heat after 2 years using . The third, stop to heat last december. Canadian Tire ( store where I bougt the product ) told me to contact Garrison Company . Now , I want to get refund. Michel L?ger Quebec, Canada
Why doesn't it heat?
either the heating coil is broken or sensor is bad, buy a new one it is cheaper then trying to have it fixed
The heater runs constantly, the thermostat seems to work, I check continuity through it, it opens and closes. What else could cause not to shut off?
QMark MUH (0521) Compact Heater Wont shut off ... - Fixya
www.fixya.com > ... > QMark > QMark MUH (0521) Compact Heater
QMark MUH (0521) Compact Heater, wont shut off related issues. Get free help, solutions & advice from top QMark experts.
www.fixya.com/support/p437492-
qmark_
muh_
0521_
compact_
heater
Recent QMark MUH (0521) Compact Heater questions, problems & answers. ...thermostat on and contactor makes buzzing noise, fan dont run but its not seized it willfreewheel when you spin it ... How do I turn off my q mark wall heater there.
QMark MUH (0521) Compact Heater Shut - Questions - Fixya
My Qmark electic heater keep tripping the breaker
You will need to provide additional diagnostic information. Most likely the breaker is defective. Warning: potential for injury is HIGH working on power electrical! Do not attempt if you do not have experience and training. Proper personal protective equipment and methods should be used. The running amps needs to be measured when the heater is turned on. Find the rating on the breaker and calculate 80% of this rating. The heater current should be less than this value. If the breaker is tripping when less than 80% is measured it is most likely defective. Measure all power legs on the heater. Also check the nameplate info on the heater Volts, Amps. Compare these values to the actual.
Muh108 single phase what size
IF it is 10KW at 208 single phase it should be on a 60 Amp breaker.
3 Phase would be 35 Amps. Always check the nameplate for additional information. It may be configurable for different voltages. Best to check manufacturers data if available.
Qmark muh won't shut off
I believe these models have a thermal switch on or near the heating element that normally runs the fan until the element has cooled. Similar to your home furnace. If the fan never shuts off this switch is likely bad. IF it takes a long time to shut off then it may be out of calibration. In either case they are non repairable parts and have to be replaced. If the heater is in a high spot resulting in a high ambient temperature it may take a while for the fan to shut down.
Not finding what you are looking for?
