Questions & Answers for: trigger catch

trigger, throttle catch and spring I am trying to assemble the trigger, throttle catch and spring. I can install the trigger (and it works) but I do not know how the spring for the throttle catch goes

the trigger does not work as soon as the air is applied the hammer starts without touching trigger Check tiny allen head grub screw has not loosened on bottom trigger button and is catching on housing

...catch on the fuser unit was still not pushing the trigger forward, causing the copier to surmise that no fuser unit was installed. At this point, you should buy another fuser unit or take your copier ...

the tip will depress but the trigger wont do anything, it seems to me that the trigger is broken since the tip isnt catching on the trigger. am i right? That sounds right. If it is driven off air, try

...You need to put it in full choke. If it is in full choke and still won't start, try pulling the trigger a bit. once you have it started in full choke, back it down to half choke and hold down the ...

trigger (some nailers have a 3m bolt w/nut or pin with rubber retainer) to expose the tva6 valve. Remove two 3mm roll pins in the body holding the tva6 valve noting the length of the roll pins. Remove

trigger valve in the body of the gun. Apply air pressure to gun and catch the valve with gloved hand (use caution because the valve may come out with force). Note the position of the valve in the body

...trigger interlock to catch so I can start it. I pressed them both at same time but does not catch. Release the interlock button first, then the trigger throttle. If this does not work, replace the ...

trigger and one or two for valve. With pins removed apply air pressure to gun popping out the valve. Use glove or folded-up shop rag to catch the valve as I pops out. Be sure to reduce air pressure as

Hotpoint wm51 intermittant start problem,door catch does not seem to trigger start process.I have removed catch,lubricated and it seems to be ok. get a new lock they are cheap