...cartridge. Reinstall and make 10 stapled sets. By the time it tries to staple set number 3 or 4 you should start to see the staples working. It could take as many as 8 or 9 sets for the staples to ...
...in the unit, take the staple cartridge out, release the leaver on the staple cartridge and remove the first sheet of staples, close up the leaver, and reinsert in the copier. then try to staple ...
Question about Swingline® 36115 Staple Guns Tools 1, 000 /box, Light-Duty, 5/16
...staple cartridge. they want you to pullout a whole inch or staples and tear them off. If your not careful when tearing off that one inch section, you could possibly bend them out of their ...
Question about Swingline® 36115 Staple Guns Tools 1, 000 /box, Light-Duty, 5/16
...staple cartridge, look into the cartrige area, are there any stray staples in this area, if so remove them, cycle the unit a couple of times without the cartrige in place, check the output end, any ...
Question about Swingline® 36115 Staple Guns Tools 1, 000 /box, Light-Duty, 5/16
staple Changed out the cartridge on the Swingline 520e. It was working fine before but now does not staple. The machinery cycles & stamps but no staples. It seems the cartridge is not advancing. I
Question about imageRUNNER 3035 Black and White Copier
...to the instructions? second: try the few times remove and insert staple cartridge in and out, until you heare the loading clicks. third: check the staple holder for damadges or residuals of
staple. 1. Make sure you have the correct staples for the machine. The type appears to be: Swingline 50050 Cartridge Staples, Chisel Point, 1/2"" Crown, 3/16"" Leg, 5000 Per Box High-quality Swingline
Question about 4110 4127 4112 4590 4595 Drum Cartridge 013R00646
...Staple cartridge stuck If the cartridge is stuck in the slide it is because there are still staples in the replaceable sleeve, if the whole slide is stuck in the finisher, you might open the panel ...
Question about WorkCentre M-24 Color Copier
...Staple Cartridge unit out of the Finisher until it stops. NOTE: The Staple Cartridge unit does not detach from the Finisher. Grasp the orange tabs on both sides of the Staple Cartridge and lift the ...
not feeding properly. I have seen a few of them fail. Remove the staple cartridge and tap it a few times on a table, you might be able to loosen up the staples, if not, purchase a new staple cartridge
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,161 Questions
2,149 Questions
1,912 Questions
