Questions & Answers for: reset counters hl 2140

...hl-2140 The blinking indicates that the drum unit is near the end of it's life. It will shut down soon and you will lose the ability to print until it is changed or reset. To reset the drum counter. ...

...LED still lit even after replacing the drum unit then you know that the Drum counter may not be reset. you need to reset the drum you can rReset the Drum counter as follows: Open the front cover. ...

...*thinks* it is) too low. You can test this by either replacing the toner cartridge (which should reset the counter inside the printer) OR you can put a piece of opaque tape on the little ...

...cannot get the lights off - have switched printer on and off When you replace the drum you have to reset the counter of the drum, otherwise it will still think it needs replacing. The replacement ...

How to reset the Drum counter You can not do that, www.brother.ca Here are some troubleshooting tips to try: ...

...of the inside of the machine. if it's a drum life error then you either need to replace it and/or reset the counter. to reset the drum counter, open the front cover, hold down the start button

replaced toner but toner light still on . You sometimes need a code to reset the counter on your printer. Which code depends on your model. Remove toner drum and make sure all proper labels have been ...

...ERROR It is possible that the drum needs replacing. Print a lifetime status page, and see if it says "drum 0%". If so, replace the drum and RESET the counters by using the reset button

HOW TO REMOVE DRUM ERROR IN BROTHER HL2140 PRINTER Need to replace drum and reset the counter (Essentially the cartridge/drum unit should not be in the printer when you reset it) 1) Open front door 2)

Drum 0% Remaining? Drum 0% Remaining? you need to install a new drum and then reset the drum counter: 1.- Open front door 2.- Change the drum Unit 3.- Press Go button and keep pressing until the 4 ...