Questions & Answers for: problems bowflex tc20

bowflex treadclimber tc 20 is putting out error codes H03,H13,H24 whats wrong this was just put together out of the box & used for 5 mins then stopped working & displays these codes I have the

when i start it up..it counts down from 3 ..then the belt starts to move then stops and shows the error codes H3 , 13, 24 Proceed with the Lube maintenance, the problem is symtom from lack of Lube. ...

H24 error code starting machine and getting H05 H13 then H24 error code one after another This a bad design in PROM, EPROM software, you must call to the factory a explain this problem.However you can

Bowflex Treadclimber TC20 error messages I'm having the same issue as someone else had with the error codes H3, H13, H24. Machine turns on...and it occurs even if you activate the GoCoach or ...

...TC20. I have had this one (this is my second Bowflex Treadclimber) for a little over two years. I perform regular maintenance and lubricate my treadles belts when the machine says to and sometimes ...

Bowflex Treadclimber TC20's left hydraulic workout cylinder does not recover to the fully up position. It stays about an inch lower than it should. I've adjusted the dials to ensure that it is between

...TC20 display panel light up, but machine won't start Generally that would indicate that the safety key is not in place, or a problem with the safety key magnet causing the machine to think the safety ...