Questions & Answers for: wrong depth - Page 2

...wrong, or did this unit fail in the first ten minutes? Adjusting the depth of the nail also changes the amount of pressure that is applied to the trigger pin. This is not actually a problem with the ...

depth of the dough hook on my mixer. Your response was right and wrong. But it was my fault. I checked and the model number is K5SS, not the one that was on the screen at the time I asked the question

...wrong button because it dosent show any fish any more it just shows terrain and the gps does not work but it is connected. i dont have a owners mauel so i need help have a lowrance lms-330c the depth ...

...depth i certain areas; but only grey colour. What are we doing wrong? The image on my fish finder has a ghost like worm going across the screen. It doesn't read structure at all but will give you the ...

...depth number blinks but does not track or change until I slow back down to idle again. Any solution? Sounds like the transducer is installed at the wrong angle or in such a way that it is getting a ...

...wrong? Thanks If these are close up photos, the depth of field will be shallow. You need to raise the ISO to force the camera to close down the aperture and increase the depth of field. Also, the use ...

depth adjustment is not set properly. Also make sure that the nails being used are the correct nails for the gun. Its possible to buy the wrong type and they look very similar to the ones needed. Here

...wrong depth. Is there a way to calibrate this. I doint know the modle off hand. It is the one that gives you two side views and stright dowm. It has the temp. and speed. If your depth is off because ...

...wrong can soon scratch or chip the paintwork. Previous experience pays dividends. There are 4 bolts attaching the hood to the hinges and also 2 bumpers at the front of the vehicle for adjusting the ...

...needle bar has moved and the needle depth is too high or the timing is wrong. Unless you know what you are doing, then I am afraid a sewing machine tech needs to reset the needle depth and the