Questions & Answers for: wrong depth Dryers

...wrong depth and were flashing between numbers and blank dashes. I have checked the transduser to see if it had been knocked up or if weed was caught around it but all looked okthe water I am using it ...

...YOU SO HARD YOU CAN NOT HOLD IT, WHAT AM I DOING WRONG? THANKS DONNA You are trying to dig too deep, too fast. Set the tines at a shallower depth and make multiple passes, gradually getting

...depth reading at about half speed of my boat You need to set the transducer lower. When at speed, the hull of the ship raises up out of the water and hence your transducer is probably not deep enough ...

...the the needle depth is to high or the timing is wrong.. Unless you really know what you are doing then I am afraid a sewing machine tech needs to reset the needle depth and subsequently the

...Depth reading are wrong, say 48 meters when it's only 2 meters. Check for depth offset, there may have been an unintended change that altered this setting. This setting compensates for

AMCCO 4000 BRAKE LATHE CHATTERS WHILE TURNING ROTORS Not enough rigidity, wrong speed, wrong feed rate, wrong depth of cut, wrong or dull tooling...

depth is showing dashes on the screen out of the water. It has not been in the water yet. The directions say that dashes means something is wrong or does the transducer just need to be in the water to

...depth adjustment on this tool - If the staples are going too deep - most likely the piston (#17) has threaded off the driver inside the tool, you have a broken piston bumper (#62) inside, or the ...

...wrong? My Lowrance Mark 5x dsi depth finder flashes or pulsates a depth of 60 ft. All the time. Since the unit powers up, we can pretty much eliminate a power supply problem. I would start by ...

...fish and loses depth reading above 15 kmh. Dealership techs say transducer &d monitor all set up OK. Wrong, if it was set-up properly it would not lose depth. Dealer is F.O.S., ... or