...machine I get an error code h-3 H3-XX codes involve the fusing unit temperature being too low or too high. Try resetting the error. [C] ? [INTERRUPT] ? [0] ? [INTERRUPT] Type in 1 4 Hit [PRINT] Turn ...
...AND TO RESET DEVELOPER does the machine stop or cannot run any copy job anymore?...if you still can copy, never mind the warning. but if you cant print anymore, then you really need a service
...24, press 7 and it will reset the developer.But 24-06 and 24-07 should clear the count and return the machine to normal. The developer and drum will normally run longer than indicated by the
...machine counters if they where reset and the parts where not replaced the machine will adjust the required voltages to certain parts thinking they are new when their old and you will get codes and ...
...reset when the developer was replaced, was the F8 process done after the developer was replaced.. If not then get new developer have the process done correctly, the machine works on what the counters ...
...reset the counter the machine will assume that a new drum is install and select the proper voltages for a new drum since the drum is not new? it might code and get poor image quality issues. Replace ...
reset that error? Have you replace the developer and the drum. First clear the counters for the drum and developer and then replace the drum and developer, then run the required F8. if not the machine
...reset the developer without replacing it, it will cause image problems or certain codes. The machine has no way of knowing if new developer has been replaced so it bases its assigned voltages to the ...
Question about EP4000/5000 CS/PRO Copier
...reset M2 error? How to enter service mode in bizhub195 Did you also replace the drum, clear the developer counter first before installing the developer, and run the required F 8 procedure after the ...
Question about EP4000/5000 CS/PRO Copier
...the counters to determine voltages for certain parts inside the machine, reset counter and not replace the parts the copier thinks they are new when in fact they are old you get codes and bad
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,161 Questions
2,149 Questions
1,912 Questions
