Questions & Answers for: amp knobs - Page 20

...amp pcb looked fine - no burns/scorches. Logitech won't repair it. Seems like the only option is to replace the system. Thoughts? try fixing its amps by simple reheating it. if still doesnt work try ...

M & S Systems MC350A - intercom dial if rotated will squeal mc350A - intercom knob if rotated into certain positions will squeal. Keep that knob at 0 volume, but it will sometimes squeal in the ...

...amp and sounds great except that the knobs and switches keep cutting out, is it safe to use a spray cleaner? which one should I use? you can use contact cleaner formulated for electronic appliances ...

...temp knob to hot it still blew cool air. No heat. The engine temp gauge is halfway between cold & hot. look to make sure coolant level is full.you may have a bad heater control module,,the

I recently bought a used spider 3 120w amp and after a few months it started acting up. first it started switching channels on its own until it warmed up (10-15mins). after a while the modeling knob ...

...signal. Some like it, some dont. The frequency knob is the Low Pass Filter (LPF) that cuts off the amp output above the set frequency. A bass system usually cuts off below 400 HZ and more often

...the control knob when lighting the pilot. Unit is about 9 years old so repair or replace? works OK & no gas smell. The gas control is leaking gas around the knob? The gas control needs to be ...

How do i turn the bass on from here for the amp hello on most car radio,s  if you press the round tuning knob on the left  hand side of yr radio this will bring up on yr display ...

high frequency noise Amp: Marshall MG10CD Clean channel works great. Overdrive Channel: high frequency noise as the gain and volume are increased. "Overdrive Channel: high frequency noise as the gain ...

...to out the wick,then try to insert the wick in its hole from below side,push gently the wick in & rotate the adjusting knob to set the wick ...