Questions & Answers for: amp knobs Water Heaters

...ALSO A ELEVATED GAS PRESSURE COULD CAUSE THIS ON START UP ALSO THE THERMOCOUPLE WORKS OFF MILLI-AMP TO TELL THE VALVE TO STAY OPEN SO MAKE SURE THE THREADS ARE CLEAN FREE OF MOISTURE AND GOOD AND ...

...relief valve. If the boiler persists in loosing pressure, look for a leak in all pipes to & from radiators. If no leak then check the pressure relief valve outlet pipe, it usually goes ...

...button on the GSW Series 5 Water Heater? If so, where? Also, am trying to drain heater to flush & can't find where to initate it. There's suppose to be somewhere (there's already a drain hose ...

...the control knob when lighting the pilot. Unit is about 9 years old so repair or replace? works OK & no gas smell. The gas control is leaking gas around the knob? The gas control needs to be ...

amp should be heaps, now connect the wire to the fixing point for ground next to the electrical box and now connect the other end to one of the chunky screws that holds on one of the gas solenoids(DON

Flashing filter light on my lux 500e thermostat turn the knob to filter & hit enter...should reset

..., turn power back on, now turn HW cold water tap to open. Now you should hear the unit start up.& click continuosly, this is the unit trying to lite. The unit has a flow sensor so as water ...

...knob all the way to full hot. Is the water then very hot? If so, the water heater is working fine & doing its job, and the problem is likely to be in the shower faucet mixing valve itself. ...

amp should be heaps, now connect the wire to the fixing point for ground next to the electrical box and now connect the other end to one of the chunky screws that holds on one of the gas solenoids(DON

...problem. If so, try draining the htr. First off, turn your heater off. If electric, turn off 30 amp two-pole breaker in your elec panel. Your elements may also be scaled up, thereby reducing