Questions & Answers for: Toyota amp knobs

...Tools required: Phillips screwdriver, small flatblade screwdriver, rachet with 6 inch extension & 10mm socket. 1. Remove negative battery terminal (for stray voltage & airbags.) 2. Remove ...

...knobs off the dials exposing the shafts which have nuts & washers on them Undo them & slide out the unit unplug wiring loom & antaenne etc from behind the unit! Cheers Rob you should not ...

...any way to adjust the brightness The odometer knob adjusts the brightness of the stereo backlight & the instrument panel. no its a common complaint,some people have covered them with a colored ...

...lock assembly... Door lock assembly Toyota Corolla 1988-1997 Repair Guide Door Locks - REMOVAL & INSTALLATION (see Figure 1) Disconnect the negative battery cable. Remove the door panel and ...

...temp knob to hot it still blew cool air. No heat. The engine temp gauge is halfway between cold & hot. look to make sure coolant level is full.you may have a bad heater control module,,the

stereo and dont forget to get both harness for easy diy install.thats what i did and it works fine & the best thing about it is i dont ever need a code again

dash lights are out replaced all bulbs, where is the fuse box located? If ALL the bulbs don't work the fuse is the first place to check. Fuse is labeled PANEL 7.5 amps under the dash, left side. ...

...knobs dont light up, but other lights on dash do If you have an aftermarket radio make sure you don't connect the orange and white wire on your wire harness this will cause the fuse to blow.the fuse ...

...doors work fine need to no what to do how to fix To fix the door knob lock, close the door slow & watch how the latch bolt meets the strike plate.The bolt may be positioned above, below, or 1 ...

...mistake) whilst changing the bulbs to illuminate the panel. buy one and install it. it has clamps remove them or unsnap them and ..... access? its in the dash. the FSM covers all HVAC work , ...