Questions & Answers for: amp knobs - Page 14

...replace the automatic shifter trim/boot. It's the part that shows the gear selections (P, R, N, D, & M). It required that I remove the shifter knob. First, slightly twist/turn and pull (perhaps ...

...How do I fix that? Model # JGP963BEJ1BB remove all the knob first,then get the vaccium to clean the bottom of the knobs control,coz some reason is dirty & ground.remove the plug b4 anything u ...

Once pulled out of the housing the bulb sockets will be visible outside of the trunk. replace the l;amps and reverse the procedure to put the light module back into the socket. Screw back on the black

what is the green round knob for on a poulan electic chain saw ? 3.5 h/power 13.5 amps Green round knob ? where is it located, could it be the bar chain oil cap you are talking about ?

AIRFLOW KNOB FOR HEATER AC ONLY WORKS ON HIGH AIRFLOW KNOB FOR HEATER AND AC ONLY WORKS ON NUMBER FOUR PLEASE HELP you need a blower resistor. The motor may be bad, pulling high amps.

...Signal Transfer) Provides Remote Bass Level Control and control signal transfer between multiple SX amplifiers Here is the manufacturer's accessory page to the remote: http://www.kicker.com/zxrc Here ...

...amp is still in manufacturers warranty AND if rotating the knobs hasn't solved the problem. If none of the above has solved the problem then the amp itself might be faulty. Don't attempt electrical ...

how to take seat off I know metric bikes I have owned there can be a release on left side like a knob.. & hindges up..look for knob.. it should pull out..

Hooking up a boss bass knob Most boss amps (i've had one), have what looks like a phone or ethernet jack somewhere on it......clip bass knob into the plug and you should be in business.....hope ...

...lock nuts under them. You could tighten them up. See if the knobs have set screws on them to lock them in place before pulling them off. On Allen & Heath, I don't think they do but, just in