...know is working and work through systematically to the other end. Test a microphone on a separate amp to make sure it works okay. Check amp and speakers working. Check that all output cables from ...
...the actual mixer need to be repaired. If so, can that be done without actually sending it to allen & heath (I live in the USA). thanks! Usually the connector that is board mounted is the problem. ...
...amp; 10, 9 worse than ten. Any manuals out there on how to repair these preamps? Thanks in advance! Jake NEVER, NEVER put contact cleaner into the faders!!! It removes the lube and the faders will be ...
...lock nuts under them. You could tighten them up. See if the knobs have set screws on them to lock them in place before pulling them off. On Allen & Heath, I don't think they do but, just in
Question about Mix Wizard Wz3 16:2 Rackmount Mixer A&h
...amp;E does not have "monitor" sends per say but instead calls them "Aux's." Adjust the proper Aux for the input channel 1-16 and use the Aux output section (row of knobs above output sliders) as the ...
Usually answered in minutes!
4 Questions
4 Questions
