2I repair for a major company
Anonymous posted an answer for this Sony KP-46WT520 46" Rear Projection HDTV-Ready Television:
"all channels and all video inputs have this two rows of white dots towards top of screen."
AnonymousAnonymous posted an answer for this Sony KP-46WT520 46" Rear Projection HDTV-Ready Television:
"Suspect a defective q-box. Some Sony sets may refer to this part as a b-board or digial..."
AnonymousAnonymous posted an answer for this Sony KP-46WT520 46" Rear Projection HDTV-Ready Television:
"the issue is most likely with the the high voltage block assembly."
Anonymous
Anonymous posted an answer for this Hitachi 51UWX20B 51" Rear Projection Television:
"If this set has digital convergence and I am sure it does and you attempted to straighten..."
Anonymous
Anonymous posted an answer for this Pioneer PDP-5060HD 50 in. Plasma Television:
"In times past that information was supplied by your PBS station. You would have to select..."
Anonymous
Anonymous posted an answer for this Mitsubishi WD-62525 62" Rear Projection HDTV:
"There are capacitors on the power supply and through out the tv that you need to replace."
Anonymous
Anonymous posted an answer for this Sony KDS55A2000 55" HDTV:
"check the fans located in the rear of the set. the fan that cools the lamp is most likely..."
Anonymous
Anonymous posted an answer for this Toshiba 50H82 50" Rear Projection Television:
"The ser needs to be converged in the factory service mode"
Anonymous
Anonymous posted an answer for this Panasonic PT-50LC13 Television:
"replace yhe lamp ballast"
AnonymousAnonymous posted an answer for this Panasonic PT-50LC13 Television:
"replace the lamp"
Anonymous
Anonymous posted an answer for this Sony BRAVIA KDL-40S2010 40 in. LCD Television:
"you have an issue with the viper ic located on the FB PCB, some models call this pcb the..."
Anonymous
Anonymous posted an answer for this Sony Grand WEGA KF50XBR800 50" Rear Projection HDTV-Ready Television:
"go into the menu and select audio and change the audio to variable and set the speakers to..."
Anonymous
Anonymous posted an answer for this Panasonic PT-50LC13 50" Rear Projection HDTV:
"sounds like the lamp driver or ballast is defective. That was a major issue on these..."
AnonymousAnonymous posted an answer for this Panasonic PT-50LC13 50" Rear Projection HDTV:
"Make sure you have the lamp door or cover installed correctly. If it is not installed..."
AnonymousAnonymous posted an answer for this Panasonic PT-50LC13 50" Rear Projection HDTV:
"Unplug the set fro about a minute or two and see if that clears the error. If you are..."
AnonymousAnonymous posted an answer for this Panasonic PT-50LC13 50" Rear Projection HDTV:
"That is because you are watching the picture in the 4:3 aspect ratio. This is normal when..."
Anonymous
Anonymous posted an answer for this Samsung HL-R6167W 61" HDTV:
"The color wheel was the cause of the loud whining noise. The only item in the set under..."
Anonymous
Anonymous posted an answer for this Planar PDP-42BK 42 in. Plasma HDTV:
"Does the lines go from north to south the entire length of the screen? and is the TV's..."
Anonymous
Anonymous posted an answer for this Hitachi 55HDS69 55 in. Plasma Television:
"that is called diffusion. that can be adjusted out in most cases by adjusting the y..."
Anonymous
Anonymous posted an answer for this Mitsubishi WT-46805 46" Rear Projection Television:
"inspect the chassis for a fluid leak."
Anonymous
Anonymous posted an answer for this Sony Grand WEGA KDF-50WE655 50" Rear Projection HDTV:
"you need to replace the optical block assy"
Anonymous
Anonymous posted an answer for this Mitsubishi Diamond WD-65831 65" Projection HDTV:
"check the lamp and air filter if there is one"
Anonymous
Anonymous posted an answer for this Dell W5001C 50 in. Plasma HDTV:
"what are you suinf for your signal? Cable, satellite or Antenna"
Anonymous
Anonymous posted an answer for this Sony Grand WEGA KDF-42WE655 42" Rear Projection HDTV:
"Replace the optical block assy"
Anonymous
Anonymous posted an answer for this Sharp LC52SB55U LCD TV:
"Make sure the SAP feature is turn off in the TV."
AnonymousAnonymous posted an answer for this Mitsubishi WD-62525 62" Rear Projection HDTV:
"this set is notorious for defective capacitors. there are many that need to be replaced. I..."
AnonymousAnonymous posted an answer for this Televison & Video:
"once a tv is returned for damage it is not hard to determine if the damage was by shipping..."
AnonymousAnonymous posted an answer for this Mitsubishi Diamond WD-65831 65" Projection HDTV:
"check the lamp"
Anonymous
Anonymous posted an answer for this Toshiba 56HM66 56" Projection HDTV:
"make sure your S.A.P feature is turned off. S.A.P. stands for separate audio program."
AnonymousAnonymous posted an answer for this Toshiba 56HM66 56" Projection HDTV:
"Replace the lamp."
AnonymousAnonymous posted an answer for this Toshiba 56HM66 56" Projection HDTV:
"you need to replace the light engine. There is a problem with tunnel."
Anonymous
Televison & Video 108 answers
