Question about 2000 Windstar
...windstar 3.8 if i have right cylinder have replaced plug and wire and still getting cylinder one misfire #1 plug is the 1st plug on passenger side by firewall I have a 1996 ford wind star van. On the ...
...windstar showing obd2 codes po303,po304,po305 and idiling ruff and wont run over 45 mph and has low miles, how do i fix it ,thanks sincerely mark might be the coil pack is bad, wires, plugs, o2 ...
...windstar has a misfire code working on a 1999 windstar se 3.8.trying to get it to go through on emission inspection. code is p1309 (misfire moniter AICE chip fault, misfire monitor disable.) does ...
Question about 2001 Windstar
...windstar 2001 lx there are four code's i need info on #1- p1401 dpfe sensor #2- lean p0171 sensor bank 1 #3 lean 0174 sensor bank2 #4 o0301- misfire #1 is the egr position sensor #4 Is for single ...
...windstar has a misfire it feels like it my 2000 windstar has a misfire it feels like it will stall at a stop sometimes wants to take off when just putting into drive or reverse changed the mass air ...
WINDSTAR IT SAYES MISFIRE ON CYLINDER FOUR I HAVE RPLACED PLUGS WIRES COIL PACK REDONE THE HEADS AND IT STILL IS DOING THE SAME THING I also have that same problem with my 99 ford windstar and i tryed
'97 windstar, no power, sluggish, misfires badly. '97 windstar, no power, sluggish, misfires badly. check the spark plugs and spark plug wires Could be many thing. Here is some. fuel ...
...windstar This misfire can come from a sparkplug wire, to a sparkplug,As for this is a window feedback, that Ford does not use in there GEM module, satisfy the misfire clear the code and recheck ...
Question about 2002 Windstar Cargo
what would cause misfir cylinder#6 and valve rattle ?misfire cyl #6 2002 ford windstar Timing. Valve Rattle? May have to have the heads done Do a Cylinder Leak Down Test --starting with #6
Usually answered in minutes!
4,236 Questions
3,747 Questions
3,350 Questions
3,279 Questions
3,218 Questions
