Questions & Answers for: wap200

Default IP 192.168.1 doesn't work , how can I setup and secure password on my wireless Hello, because default IP is 192.168.1.1 not 1.92.168.1 Leave rate if I helped you, thanks!! Cheers, Mike

Cannot access the config menu. I've tried the default IP both connected and wireless. I've reset the unit still nothing. I can get on the net so it works in that aspect but I can adjust anything. Help

AP is broadcasting SSID but can't get ip address from DHCP server. POE light is on, but ethernet link light isn't on @ AP or switch. May have been connected to a faulty cable. Any ideas? Is the ...

One of the antennas is loose on the WAP200 (used) I just bought. It doesn't tighten up firmly. Is there a way to open the device and fix whatever is spinning on the inside of the antenna bud? Thank ...

I need to locate the default IP to my Linksys WAP200. The default has been changed and the owner cant remember what it was changed to. The owner cant afford to lose the configuration settings. Plug a ...

AP Client can't get ip address from DHCP server. With static IP address communication work properly between client acces and the network. Dear all just disable wireless isolation [between SSID]

hallo, i recently installed and configured a WAp200E-EU-UK access point. i changed the default ip address to 192.168.1.11 and changed the SSID and key, when i logged out of the web interface, i could ...

I could not access the web based configuration/setup page for my Linksys wap200 once u put the wireless access apoint in your network check ur dhcp server there u will find in ARP table the ip of your

CISCO WAP200 constantly loses connection I have a new Brother MFC 9970 printer connected to the WAP. I have the printer set to static IP. After 15 - 20 minutes the connection is lost. If I restart the