Questions & Answers for: OKI top of form Computers & Internet

...Top of Form. I don't know if someone accidentally changed a setting or something but now the printer feeds after printing as if the form were 11" in length. The perforation is above the tear Off ...

top of the fifth form. THat is it prints the first form correctly, but with the wrong length(11 inches) and then does another form feed. Consequently we are wasting 3 forms for every one that we print

...Top Of Form setting procedure, so you can adjust the minimum space between top of porm and first printed string (user's guide explains in details how to do it). But after that you need to decide ...

...form is approximately 1 line short of the top of page. This is progressive, so that eventually it begins printing on the same page again. This problem occurs both in my retail (DOS) program, and when ...

top of next form Using Quickbooks software. When printing invoices, the printer will not advance to the top of the next page. it starts printing the next invoice on the bottom of the previous invoice.

Where do I find instructions on how to reset top of form on the printer http://my.okidata.com/pp-ML320.nsf/openingdrivermenu?OpenFrameSet

...Top of Form (where the printing should begin) is one inch down from the top of the page. To change the setting, see "Using Your Printer, Top of Form (TOF)." Top Feed (Single Sheets) Use the ...

...Top of Form, Forms Tear-Off ON (Step A) ! If you turn the platen knob when the printer is turned on, you will cause the Top of Form to mis-align. Always turn the printer off before turning the platen ...

top of form (TOF). If the TOF ever gets thrown off you can press "LINE FEED" until the tear is where you want it and press "SHIFT" > "TOF" to back back to the previous page (or top of form). Simply

...top of form .75" from the top of the page. What is causing this additional 0.75 skip? There could be a few possible reasons why your Okidata Microline 280 Eco printer is jumping around 0.75" for each ...