Questions & Answers for: tempature probe

F2 code Is the sensor the tempature probe in the oven or is it in the control panel? Where is it located? the sensor is the temp probe it is in the oven My electric stove top shows f2 and f5 message

...probe,speedometor,oil gage,odometer not working fuses in car good rpm gage,gas gage,tempature gage works You need to pull the dash and check the guages look for any burning or melting. You may just ...

...tempature probe circuit is open. The temapture probe may have been damaged due to the self-cleaning cycle or it could just be the wiring harness is loose. You will need to remove the tempature probe ...

...tempature probe with an ohm meter. At room tempature the probe should test 1000 to 1100 ohms. If you get a reading that is out of range or different ohms than rated replace the probe. If the probe ...

tempature probe to see if it is defective. Test with a OHM meter and at room tempature most probes should read around 1100-1300 ohms. if the reading is way off or open then replace the tempature probe

...tempature to get hot water The thermostat probe inside the tank is scaling up with mineral buildup. You can drain the tank and then remove the control. Soak the thermostats probe in vinegar and a ...

do you use the tempature probe? Insert the probe into the center of the meat, in an area where it's likely to cook the slowest. Anything above 63 degrees celcius is considered safe for consumption

kenmore range indicator light for element does not shut off Tempature probe(Temp sensor) on that burner is malfuncting . Replace that probe. www.searspartsdirect.com/partsdirect/brands/kenmore-parts

tempature. Then the Themostat was replaced with the same result. Today the Fan has been replaced still with no improvement, any ideas? First need to see if supply voltage is correct. Verify oven probe