Questions & Answers for: Sony switch pcb Computers & Internet

...(Generally mentioned as Q801 in most SONY TVs) Slide the PCB back in, and close trhe set. Try switching it ON

pcb.Allso try turning tv completely off at the mains switch leave a few hours then switch back on.If you decide to take to A repair shop this repair is not expensive. http://dysonmanuals.inc.io/ Chris

...when I try to turn on the TV ...TV standby LED blinks for 9 times and it doesn't turn on. I tried switching off the power supply completely ..but no luck. Check your power supply board and resolder ...

...switch tab on the pcb board. I replaced the pcb with a new one from ebay but it will not start up or the charging light will not come on. Many thanks Andy W Hello Andy, Have you checked that you have ...

switch module (~$10 on ebay). That PCB is pretty basic, so if you are good at soldering tiny parts, IN PRINCIPLE, you should be able to fix it. That said, you must be certain that the switch itself is

...PCB and switch will render the entire TV non-usable. You could defeat the switch but it is not a good idea--up to you--it is a safety switch so the set cannot be operated with the door open. The ...

switch on and I smelt burning. I unplugged it and realized my mistake. The light now stays red and switches green for a couple of seconds when pressed and the disk drive starts moving before the light

...switch. I want to quote a new pcb in order to replace the damage pcb. The failure was produced by a crash of the ICB SW35 Sony radio over the floor at home. Hi, Required board part number is as ...

...tv, try to locate the power switch by looking for the power button, It is connected in a small pcb together with the volume and channel button it is separated to the main pcb connected with a

...the switch. These models have a common problem with the solder connections between the switch pcb and display pcb going bad. You need to resolder these connections, and your problem should be