...1) Focus control (to see if the problem can be soled by adjustment) 2) IHVT anode (test to see if voltage is correct you will need a schematic and a high voltage probe) 3) CRT Socket board ( Check to ...
1 for the Call Forward settings. Sounds like you have changed the Divert all calls option. User Manual is here if you need it; us.lge.com/download/product/file/1000001457/CU500_UG_Eng.pdf Best of Luck
...sharp blade, cut around the wire about 1/4 inch from the tip. Do this Gently so that the copper inside is won't be cut. Pull off the plastic to show the smaller copper wires inside. Use the blade or ...
...sharp. I have also used a No.2 Jewelers screwdriver, in lieu of the X-Acto knife. Depends on the type of screw cover. (Soft rubbery covers I use the Jewelers screwdriver) There are usually 4 screws ...
Question about X3-02 GPS Receiver
...1/4 inch from the edge of the board. If you press down on the contacts of the trimmer one at a time you can find out which contact is causing the problem. Heating the contact with a sharp tipped ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
