Questions & Answers for: rode nt1

Rode NT1-A Distortion on "S" sounds and plosives This problem started all of a sudden. The sound quality is degraded doesn't sound like a decent condenser anymore and there's terrible distortion on ...

to a Rode NT2 microphone when it's switched to Cardioid Response. I can't see a mark to indicate 'Front' as there is on the NT2A or NT1. Thanks I believe the front is the side with the response switch

...Rode NT1-A mic is a very good microphone, specially for vocal recordings, but as most of the proffesional microphones needs a power supply. To be more spesific when you use your NT1-A with an audio ...

My nt2 started to cut out and fade out so I pluged an nt1 on the same cord and it works fine Send it back to Rode and if its not caused by Misuse, should be covered under their 10 year warranty.

Does the NT1A work with the M-Audio MobilePre USB preamp? The NT1-A will work with any mic preamp that has phantom power.

i just brought the nt1-a and plugged it in to my cakewalk UA-25 EX and nothing ...No sound from the mic ... Be sure Phantom power is on. Check that other mics or sources work properly through the ...

I'm using a piece of software called Audacity. When I record using my Rhode NT1-A condenser microphone, the sound isn't as clear as I'd like it to be and I'm sure it can be clearer. NO IDEA WHAT TO DO

a problem with my brand new NT1. The pre-amp was working as was an old mic but when I plugged my new NT1 in, nothing. After swapping out cables etc, I updated my Rode AI-1 and bingo! The mic now works

...Rode NT1-A mic. I was able to use it for about a half hour, and then upon the next use of it the sound was almost inaudible. What could have happened in that time? I put it away and everything. Your ...

...nt1 lots of static, when its just sitting there plenty of static??... surely this cant be normal? This is a problem that's not too uncommon. First, you need to determine if the mBox is at fault, as ...