Questions & Answers for: what does the resistor block do

...resistor block (Hot). Do not operate the blower motor with the resistor block removed. Disconnect and isolate the battery negative cable. Remove the glove box from the instrument panel (Refer to 23 - ...

...resistor block contains several resistors. As you alter the blower speed, different resistors are used. One of yours has obviously failed. You need to replace the resistor block, which may be located ...

...block into the resistor was partialy melted. The blower has stopped workin again. I looked at the new resistor and the situation is the same as the original. I did notice when I replaced the resistor ...

...High is just a straight power application, outside of the resistor block. Replacing your resistor block should take care of the problem, but inspect the wires and connections before replacing

...resistor assembly is underneath the fuse block REMOVAL & INSTALLATION Disconnect the negative battery cable. Remove the rear sight shield. Remove the fuse/relay block assembly and bracket. ...

resistor block: Caution: Stay clear of the blower motor and resistor block (Hot). Do not operate the blower motor with the resistor block removed. 1. Disconnect and isolate the battery negative cable.

...resistor block. The resistor block controls the speed of your fan, and it looks like the circuit in the resistor block have just blown up. You could buy the part you needed in your nearest parts ...

...resistor assembly is underneath the fuse block REMOVAL & INSTALLATIONDisconnect the negative battery cable. Remove the rear sight shield. Remove the fuse/relay block assembly and bracket. ...

...resistor block. inside the resistor block you can see coils that are soldered to a terminal.check if there are coils that are broken or not soldered in the terminalresistor blocks are located below ...

...resistor block. You test the resistor block using an electrical multi-meter, set to the Ohms scale. Using the meter's test leads, check the following: Between terminals 2 & 3, you should have 2.3 ...