Questions & Answers for: reset switch ge washing machine

...to tell us to reset the pressure switch...... We just had GE repair technician tell us to open and close lid 7 times to reset computers. 5 Times worked for me - thanks so much for saving me the

...reset the circuit by unpluging the machine and opening and closing the lid more the 10 time. No positive result. Need Help. Thanks hi thanks for the question. i think the problem is with the lid ...

...switch?mike My GE washer was doing the same thing. We called GE to come fix it since it was still under warranty. The tech unplugged the washer for 30 seconds, plugged it back in then open and closed ...

...reset the off balance switch? Check the lid switch for continuity. Bad lid switch= no spin. You could also have a reset in one of the knobs. It could be the push in pull out control knob OR the water ...

...reset" and then check to see if it resolves the problem. It did with our washer same model and problem. Best wishes.... Doug Set the machine for spin and turn it on. If it spins, replace the water ...

...switch (?)switching the machine off. After aproximately 1 minute, it will reset itself and will start working for another 10 seconds and stops again. Other than this problem, the machine works ...

...reset the machine...no luck yet. The LED indicator light on the system board flashes normally. There is a fuse under the top cabinet running down to the motor. It is small it looks like a shrink wrap ...

...GE topload washing machine model #GCWN4950DOWS and I load my clothes and press start, but the washer just beeps and does not start fill cycle. Washer has worked previously. Tried unplugging and ...

...reset push and hold any two buttons until you here a beep or for 20 seconds,or try pushing the on/off button for same.or try pushing the door closed again ,.the door switch if not closed propyl will ...

reset (lift lid 6 times). To no avail. Lid switch is magnetic. make and model information might help. try contacting the factory for guidance if you have those pieces of info. age might be a factor...