Question about Novotronic Premier 500 Front Load Washer
...stem & seal need to be replace, the tub bearing has to be replace at the same time. This is an expensive repair if you have to pay someone to do it. If you do it yourself it will cost you about $110 ...
...stem & seal need to be replace, the tub bearing has to be replace at the same time. This is an expensive repair if you have to pay someone to do it. If you do it yourself it will cost you about $110 ...
...leaking from ) replace the o-ring and the stem to be safe. Also take a look at the micro sw to make sure it doen't have any corrosion if so replace it. If not your on the road to recovery. Good ...
All the knobs have cracked stems. I need replacement parts. My knobs did the same _ if you want to avoid expensive replacements (mine were going to be $125) get some small good quality zap straps and ...
...The knob on the front to control the settings has broken off at the stem and needs to be replaced. In addition, the part where the knob stem went in seems to spin freely without adjusting ...
...replace it. Other ovens use a mechanical system to control the temperature. On many models, you can adjust your oven thermostat using a small screwdriver. The adjusting screw is located on the ...
Usually answered in minutes!
243 Questions
129 Questions
64 Questions
55 Questions
59 Questions
