...color wheel inside. i have a sharp 65DR650 and it is showing a message in the screen (replace lamp) is it something that can be replaced, if so, where can I buy the lamp and whats the aprox
...replace the lamp. If the problem still persists the light engine is likely bad. The light engine is about $1000 plus installation. The lamp is $349. the same thing happenned with our shar dlp 65" and ...
Question about 65DR650 65" Rear Projection Television
...off the unit the lamp indicator still flashing around 4 min,and stop.Need some advise please.Leo I replaced my lamp and the picture is still bad sounds like your system board is really shot ....did ...
...lamp. Its thin cable sticks out from the case. You will to open the back panel of the TV, check for cables, remove screws for the base on the right, then pull out the base out. You will have to be ...
Question about 65DR650 65" Rear Projection Television
...is...thanks Well you could replace the lamp that would be a cheaper approach then buy a new TV. Now these lamps should run over 4,000 hours but I could be wrong its all on the manufactures
Question about 65DR650 65" Rear Projection Television
...replace lamp worning last month and a couple of days ago it just when out and would not turn on anymore. i finally got a replacement lamp for it but when i instald it i get nothing. the blinking ...
...REPLACE LAMP NOW i just moved and when i set my TV back up, and turned it on, it read, " FINAL WARNING! REPLACE LAMP NOW! Can someone please tell me what is going on/ All rear projection TVs has a ...
Question about 65DR650 65" Rear Projection Television
...replace this part and where is it. My tv is a sharp 56dr650 dlp. HELP What is Wrong with TV? Have you replaced Lamp? If so and still no picture then it can be Ballast Board it connects to Lamp Box , ...
Question about 65DR650 65" Rear Projection Television
...lamp out and put it back in today, and still everything is red. Any ideas what the problem might be? That humming noise was your color wheel going bad. It is part of the optical engine. I am not sure ...
...replace lamp ockieandlolo, I have a tip which should help at http://www.fixya.com/support/r4168009-change_lamp_in_dlp_projection_tv . It explains the remove and replace process and also where to get ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
