Questions & Answers for: pull string hard chainsaw

...Pull String The pull string/rope on my Dad's chainsaw broke. We rewound it but now it does not fully retract the rope after starting the chainsaw. Does the spring need to be pre-tensioned a couple of ...

pull in position inside the tank. I threaded the string through the large tube an tried to push in the hole. After I finally got the tube in the hole I pulled the coupler into the tube inside the tank

pull string hard to pull new saw. too much oil in the fuel, or set screws are not mixing air fuel properly. have the set screws looked at, and listen for a bearing to be gone, there are two un related

...string you should feel small bursts of air and feel resistance on the chain if not the cylinder most likely has lost compression and needs new piston rings. Also, check that the spark plug is firing ...

...pull string does not pull smothe, and I can pull fast enough to start it, its like it's catching on something If the tiller was stored for awhile mice will get in to the flywheel section and build a ...

...PULL STRING ON CRAFTMAN MODEL358791050 You hand winde it in a CCW direction BEFORE installing the rope all the way until you feel significant resistance. (It really helps if there are 4 hands doing ...

...hard to start, the cord is stuck already. It won't move at all when pulled. Like a cheap yo-yo string. are you sure you mixed the gas/oil mixture properly?and if not the engine might have ...

hard starting and excessive smoking.If the chainsaw/trimmer is over a couple of years old, then I recommend that you buy and install a new carburetor repair kit,because the diaphragm will get hard and

hard starting and excessive smoking.If the chainsaw/trimmer is over a couple of years old, then I recommend that you buy and install a new carburetor repair kit,because the diaphragm will get hard and