Questions & Answers for: printer fails to switch on Computers & Internet

...If I wedge a small screwdriver under the power switch to apply pressure to it then the printer will work just fine. I think having it fixed would be to costly unless I could get it apart

...printer hardware fails somewhere. To find out what section fails, you can press down the ?go? button and a led will go on. Toner >> FUSER FAIL Drum >> LASER UNIT FAIL Toner + Paper >> MAIN MOTOR FAIL ...

...printer only flashes feed light Have tried to switch off and holding down the feed button but to no avail. When this machince does not want to print its so frustrating These printers have really weak ...

...switch fails to turn ON 2.5 sec after scanner motor starts to turn in normal direction. .Home position switch fails to turn ON 6 sec after scanner motor starts to reverse. Solutions: .Defective ...

printer off for 2 minutes and switch back on. If this fails you may have a faulty cartridge, try using another one to confirm this. Please also ensure the issue is with the same cartridge you replaced

the unit wont turn on There is a power supply under the cover where the copies come out, I suspect that, or hopefully a fuse failed on the board. Less likely, but I have seen them fail, the main power

Printer fails to switch on when the on/off button is pressed. fail to switchon two possible cause: prinhead is defective power supply is defective remove the printhead if the printer power on properly

...Switch on the printer. Press and hold the Stop/reset button. Press the button that you use to make a color copy and hold it down. Wait 5 seconds. The printer now reboots and sets itself up. ...

...error code on the Ibm printer 4224 Attachment Card Failed Power on Tests.1. Switch Power off (O).2. Wait 20 seconds and switch power on(I).3. If the printer displays (19) again then call for

...printer ON again and repeat the Hard Disk Drive Test. If the Hard Disk Drive Test fails again then replace the Hard Disk Drive. 2 If the Hard Disk Drive Test passed after removing the EIO Card,then ...