Questions & Answers for: Alcatel node 100 Computers & Internet

Newbridge 3600 circuit signal fault I am running a short hop from my NB 3600 at one substation to an NB 3630 at another less than 2 miles away. I am connected by T-Marc fiber boxes at both ends and ...

can't access to alcatel 3600 node managment station from faceplat i think BD9/RJ45 cable pinout not ok , could you pl,s provid me the pinout wiring cable for SP1 to access to inactive controler shelf ...

...CPSS recourses are configurable at 64K 16K etc. Each CPSS recourses are dedicated to a specific node and can only be used once. A shared CPSS recourse is exactly what it means, it a sheared ...

We have our all Nodes on our network . They are accessed by NMS at our HQ . But the problem is that When we locally want to access DXX Node via ANM , it is not accessed.Also DXX Nodes SP1 and SP2 are ...

CPSS CONNECTED TO SP1 OF DXX CHASSIS When I Check for list of CPSS connected on my DXX node , I found one CPSS connected to Serial Port 1 of chassis . Somebody before me has done this now he has left ...

CPSS doesn't seem to work Hello, I want to enable CPSS on a E1 link between two newbridge nodes. The ports are configured ok but it doesn't seem to work. We use TS0 for CPSS. If CPSS works on that ...

We have tow nodes working as a dual shelf A & B. The control card in B is the main and working probably but the backup control card which is in A doesn't carry the load when we switch the load ...

...reasons why the call will be dropped. The call will be dropped when you aggregate link between the nodes fails, if this is not the case monitor the connections on the node and see if the connections ...

reset newbridge 3630 data node to default To reset a 3630 you need to go to Maint and restore the database, it will ask you which database to restore just hit esc and it will reset the database

...is properly set for CPSS and you will have to use a craft interface to log on talking CPSS to the node. The S1 switch on the control card is to reset the database on the node, but you can also use ...