Questions & Answers for: mark hexagon

...mark on the oil pump. Fig. 1: Line up the punchmarks on the sprockets with the marks on the rear timing belt cover before removal of the belt Loosen the timing belt idler pulley bolt. Using a hexagon ...

...hexagon wrench from the tensioner. (h) Slowly turn the crankshaft pulley one revolution, and align its groove with theATDC 60° mark of the No.1 timing belt cover. NOTICE: Always turn the crankshaft ...

...mark on the camshaft sprocket (located on the trailing edge of the tooth). Loosen the timing belt tensioner lock bolt. Insert a 6mm Allen wrench into the hexagon opening located on the top plate of ...

...hexagon wrench, install and uniformly tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown. Torque 58 lbft. Then mark each head bolt and turn each one an ...

...this car is AUTO the dipstick will be on the same side as the gearbox underneath the hood. clearly marked with a red (i think) coloured plastic handle you check the level with the engine running and ...

...from oil or water. When installing the timing belt align the white lines on the belt with the punchmarks on the camshaft and crankshaft sprockets. Have the arrow on the timing belt pointing toward ...

...hexagon and the filler plug will be around the half way up the gearbox mark but it can vary between teh wheel side or the front on these cars fill with EP90 hypoid gear oil but in all honesty i never ...

...the key on the plastic part. Put that into the hexagon in the key panel and twist in the direction marked to open and bingo.... Its open!! (NB. The plastic cog behind the key contains a miniature ...

timing belt diagram marks for toyota corolla 1996 timing belt diagram marks On the 4A-FE engine do the following: Align the camshaft knock pin with the knock pin groove on the pulley side with the K ...

...hexagon wrench in the order shown in the illustration. Torque: 70 N·m {714 kgf·cm, 52ft·lbf} (c) Mark the front of the cylinder head bolts with paint. (d) Further tighten the cylinder head bolts 90° ...