Questions & Answers for: ignitor wet

The voltage regulator on the control module is sending the wrong voltage to the ignitor or the ignitor is getting wet from condensation. That ignitor should last many years. Replace the control module

...The ignitor module is probably wet, or has failed, or the switch on your burner control has failed. Ignitor is usaually on back of unit, toward the top. I would concentrate on the ignitor

ignitor keeps sparking not wet or dirty even when no burner on Will most probably be a problem with your ignition box. If you want to test this try taking off the hob by undoing the screws under the ...

...ignitor is no good if it got wet also you could dry off the igintor or replace it.ignitor or pilot light will be under a small door on the back of the dryer about where the gas line goes into the ...

...it doesn't you need to change the ignitor.when you go to remove the screws that hold the ignitor on wet the threds with a wet paper towel and the screws will come out easier than if they were ...

ignitor,,with a wet paper towel wet the screw threds on the two screws with water so they don't strip out and then remove the two screws holding the ignitor on,trust me it works.if you have to, unplug

...wet and is suppose to be sealed so wetness cannot get inside the unit. What is the solution to fix? norman@pacificsupplies.com Norman Dole 714 321-3653 cell One or more of the ignitor switches has ...

ignitor.wet a paper towel and wet the two screws,they will come out easier,you can't use wd or anything like that because it will smell when you turn the oven on so use water, if you can see where

ignitor screwed to the burner tube,wet the screws with a wet paper towel,they will come out easier or if it makes it any easier remove the tube and then remove the ignitor.first start the stove if the

Fl 4error FL 4 means ignitor problems first check to see if the fuses in the black holders are good if they blow again need new ignitor fuses might have blown if the ignitor was wet