Questions & Answers for: hold 6 replace drum

...hold down the 3&6 keys while turning on) [36 mode menu screen] Press the [13. Counter clear] key. [Counter clear screen] Press the key corresponding to the item to be cleared. Message in the message ...

... With the door still open hold down the go button for 1 second 6. Put the toner/drum unit back in 7. With the door still open hold down the go button for 1 second 8. Close the door and press go to ...

...Hold the drum at the ends and never touch the drum surface. ? After removing the drum, keep it in the drum case or storage bag to protect the surface from light. Prucedure 1. Remove the image ...

6 12: Remove the tape used to hold the belt in place 13: Replace the rear cover (make sure the vent tube is seated correctly at front and rear). Tighten all screws. Step 7 14: Replace the Fan assembly

...6 times on one printer and it still goes fine . 1. turn the printer off 2 . check that the front cover is open 3 press and hold the go button and while holding turn the printer on . 4.check that the ...

...paper. You will need to replace the drum every 5-6 toner cartridges you use. This means that the ink of the toner or drum is near to finish. Please refill your toner or drum ink as soon as

...6 pristonero, there is no "main" button. what are you talking about? open the top cover press and hold the main button wait till all light where up release then cover, that should do it The ...

...hold the Go button for about 4 seconds until all the LEDs light up. Once all LEDs light up, release the Go button. 3) Pull the print assembly out of the machine. 4) Push down the green lock lever to ...

cover of the printer 5.Press and hold down Go button for about 4 seconds until all the LEDs light up. 6.Once all 4 LEDs are lit, release the Go button 7.Close the front cover. 8.Your drum is now reset