Questions & Answers for: grohe o rings

grohe ladylux cafe faucet removal How do I remove the ''odd'' retention ring underneath the sink? All the water supply lines prevent it from turning and I'm not sure how to dissamble the faucet from ...

Ad

Question about Integrated 1/2'' Shower Thermostatic Rough-In Valve With Stops - 3412

1 Answer

whenever i pull out the head on my grohe ladylux faucet, water starts to run back along the hose and down under the sink. i've replaced the head itself and the o ring but it still does it. can anyone ...

Ad

Question about Integrated 1/2'' Shower Thermostatic Rough-In Valve With Stops - 3412

1 Answer

...an anti-scald adjustment on the faucet that needs to be turned up a few notches. Havent adjusted a Grohe faucet but most faucets you rmove the handle and behind the handle is a nothced adjustment ...

Question about Grohtherm Thermostatic Rough-In Valve 3/4'' Valve - 34125000

1 Answer

Grohe valve Grohtherm Thermostatic Rough 34-126 I turn the mixer to full hot but the temperature remains tepid. All the other faucets in the The thermostatic stop is set too low. Havent set a grohe ...

Question about Grohtherm Thermostatic Rough-In Valve 3/4'' Valve - 34125000

1 Answer

...rings. Normally your hot water shouldn't be more than 120 degrees F. You can check this by holding a thermometer in the stream of water with the hot on only. Grohe has a lifetime warranty on them. I ...

Question about Grohmix Thermostat Valve & Trim - 34436

1 Answer

I have a grohe 19 614 thermostatic valve / mixer. I want to adjust it so that the wateris hotter than what is coming out right now. I have the diagram showing how to take the trim off, and shows where

Question about Grohmix Thermostat Valve & Trim - 34436

1 Answer

grohe shower mixer, water always warm, never hot, even when turning temp up ? There is a hot temp limiter that comes from the factory set too low, often. typically you remove the handle and there is a

Question about Grohmix Thermostat Valve & Trim - 34436

1 Answer

...Grohe 46 078 000 - Mounting Set they should be other o-rings washers etc. Please advise. Thanks John Hi, Yes... your setup should look like the 46078000 at this point i would just buy that for the 28 ...

Question about 32924000 Tenso Single-Handle Centerset Lavatory Faucet with Pop-

1 Answer

...causes grohe tenso to leak at the body and spout location There is a screw access hole at this location which allows water to leak. Most likey the "O" rings on the spout body are bad, need

Question about 3427 Concetto Single Hole Bathroom Faucet - Chrome

2 Answers

...Grohe experts if it is a single lever action ( lift up --turns on and left right is hot or cold ) it is most probably a ceramic insert model If that is the case the fix is a new insert as they cannot ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plumbing Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

Brad Brown

Level 3 Expert

19190 Answers

Tim Hofstetter
Tim Hofstetter

Level 3 Expert

1407 Answers

Are you a Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...