Questions & Answers for: float switch ice

...float switch next to it tapped seems to be sticking than goes tru cycle rev. heat into tray but makes no ice - could it be circuit board or valve problem? the water pome geting to hot and not raning ...

...Float Switch stuck in the up position.=Empty sump, remove float switch (Carefully and watch the small pin that keeps the float inside). Clean and reassemble. Water Valve leaking by:=Only fix is to ...

...float switch is stuck, it stays in the fill/ harvest mode. Compressor runs and water circulates but no ice is being made. I'd start looking there. Turn the machine on, let it run for about 3 minutes, ...

...float switch. It fell out small bracket does not go inside, but outside the float switch. It goes behind where the float switch mounts. A screw goes thru the float, the bracket, and then into the ...

...float switch. Where is the float switch located. The machine and condensor has recently been taken apart, cleaned, new hoses installed and the system evacuated and re-charged with freon. float switch ...

...float switch. unit fills with water for 1 minute, then the board "looks" at the float to "see" if there is enough water in the unit to run. If float switch is stuck down, it tells the unit there is ...

...float switch still no change what else should i chek. if you are sure the float swith is good and the dip switches on the board are correct, you most likely have a bad 1 minute timer on the control ...

hoshizaki float switch what is the issue with the float switch? be more specific?

...float or the switch. If you are not familiar with electrical appliances or if you are unsure of how to fix the float system, it is highly recommended to call a qualified technician to diagnose the ...

...float switch and water valve. It has harvesting problem. If I hit the float switch it stats harvest cycle. If I don't hit on time it goes to 3 times beeping and I need to reset it start the machine ...