Question about 4-Button Remote Start/Keyless Entry with DP II Technology
...flash but car will not start. Any suggestions? Thanks. one thing to check is the metal cage that holds the battery. The solder points on mine broke free of the circuit board. I resoldered and all was ...
Question about 791XV The 791XV is a 2-way Security and Remote Start system. Th
...remote starter work or aux( trunk ) ? also when putting the battery in the remote , be easy because there is a connector plug soldered on the board real close to where the battery is , and if it is ...
...starter is drawing more than the rated amperage, and/or that the relay for the remote start system is damaged. It could also be that the remote start has to be reprogrammed after having been without ...
...remote starter. Try starting, if theft light still flashes leave key in the on position after attempted start for 15 minutes till theft light goes solid, turn off and try again. Repeat process for ...
Question about 5501 LC3 SST LCD 2 Way Car Remote Starter System
...flash that it's trying to start. My doors lock and unlock and all that so I don't know what's up. Any thoughts? you can try and reprogram the "tach". it sounds like the bypass module is working since ...
...flash if nothing else works.The usual way to operate the remote starter with this remote is by pressing the * button once but, the option could have changed if the remote has been reprogrammed ...
Question about 5101 LE 1 Way Car Remote Starter System
...Reprogram the remote: press and hold the f button for approximately 8 seconds. the remote will flash three times. press the remote start button on the remote. the remote is now ready to pair. enter ...
Question about 5101 LE 1 Way Car Remote Starter System
...flash If the remote worked before, the first thing to try would be to reprogram the remote to the truck. Manuals are available online if you don't have one. Another problem could be a bad remote, try ...
Question about 5101 LE 1 Way Car Remote Starter System
...Reprogram the remote on remote press the middle button for 15 sec. after three flashes on remote, put key in ignition and turn ignition on but dont start it. press button on antenna, release and then ...
Question about 5101 LE 1 Way Car Remote Starter System
flash one time and the horn honks to confirm entry into remote programming. 4. Press the button on the remote control. 5. The horn honks to confirm the remote has been programmed. 6. Release the Valet
Usually answered in minutes!
359 Questions
288 Questions
311 Questions
218 Questions
215 Questions
