Questions & Answers for: fault code p1336

...fault code and will changing the CAM Sensor correct? Or is this going to become one problem fix to find another? I would think it would be just the Camshaft Position Sensor.I looked up the codes and ...

...code refers to a problem with either the cam or crankshaft position sensor If this fault is present there are only a few things that could cause this. 1st, If this is just a MIL, but no running ...

...code - if it recurs, change the sensor. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question. NISSAN OBDII DTC P1105 Manifold Absolute Pressure/Barometric ...

...Fault P1705 Throttle Position Switch Circuit P1706 Park Neutral Position Switch Circuit P1760 Overrun Clutch Solenoid Valve Circuit P1900 Cooling Fan Control Circuit sorry but your code reader is not ...

...fault code stored in your onboard computer - that's the way it works.  If you are using a generic OBD code reader, that is most likely the reason you cannot find any codes.  You need to ...

Fault code p1336. Both cam/crank sensors have been replaced. Fault code still present. Could it be that computer has not reset yet? There are two possibilities... The crankshaft and camshaft sensors ...

...not need to be recalibrated , the ecm should have the codes cleared . Then turn the ignition system on with data reader hooked up to see if sensors repaired the fault code. You need to clear the

...fault code P1336 TEC not learned mean I have always done it with a scanner. You can try it without one. Start the car. In park, run the RPM's up to 3000 for about 15 to 30 seconds. Let it idle for ...

Fault codes/ P 1385, P2339, P1336, P1340, P0562, V2000 ? V1218? Any help with these would be appreciated, not sure about the last two though!! Car ran rough in driveway then shutdown , car is at ...