Questions & Answers for: Hotpoint which draw for the powder Computers & Internet

Question about WM56 Front Load Washer

1 Answer

...draw but not for the powder please help Assuming that the bit the water is going into is the prewash dispenser (rather than a bleach or conditioner dispenser), why not just put the powder into there? ...

Ad

Question about Aquarius WD63 Front Load Washer/Dryer

1 Answer

...powder draw when the draw is closed Hi, i have a secondhand hotpoint wd62, i have cleaned all the draw and inside and placed the draw back in with powder, but when the water comes into the draw to ...

Ad

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...powder and conditioner which needs to be removed. how do i take the drawer out? pull the draw out as far as it will go, there is a blue tag in the middle to the back of the draw, push this down and ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...starts water pouring out drawer take your soap draw out and seif it blocked sometimes the washing powder blocks the pipe to the drum you could also try and boil you kettle and poar in the soap ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...leaks out of the washing powder tray when it starts to drain. water leaks from the draw when spinning is normaly due to the sump hose(filter) blocked,the filter is fitted into the bottom sump

Question about WMA58 Front Load Washer

1 Answer

water leaks through wash powder draw and door itself Water leak from drawer could be if the machine is leaning forward slightly and the leak from the door could be your door seal may need replacing.

Question about Aquarius WMA56 Front Load Washer

1 Answer

...the powder draw from the aquarius wml520, please? 1. Extend the dispenser drawer until the stop is reached. 2. Press the locking tab located in the centre rear of the drawer and pull the drawer

Question about Aquarius WMA42 Front Load Washer

1 Answer

...the pull out section were powder goes even the water pressure to the washing machine is too high, the machine is tilted forward or a blockage in the soap hose/ draw inner preventing water going

Question about WMA64 Front Load Washer

1 Answer

...softner and powder draw hole gets gunged up stopping water supply take drawer out and clean then clean inside where draw fits black gunge blocks small hole where water comes through should do the ...

Question about WMA64 Front Load Washer

1 Answer

...ideas why? Thanks Try removing the draw and cleaning it thoroughly i would recommend running a few hot washers with no powder through the machine ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...