Questions & Answers for: double pulley problem

Question about 1998 Legacy

1 Answer

...bottom pulleys double marks. This should line up the single lines on bottom pulleys with 90 degree mark on outer cover both sides.The center pulley for crank should be straight up with notch in

Ad

Question about 62602 Electric Dryer

1 Answer

ken more 90 plus serious cant get belt on hi i assume you cant get on the pulleys . double the belt ant slide your doubled belt under the idle and to the motor you will feel the tension when you put ...

Ad

...Hi , If it is the "anti wobble" pulley on the double fanbelts - I did drill out the rivets and replaced the bearings then bolted them back together with some capscrews and nuts. Johan - South ...

...double mark up with the mark on the passenger side cam pulley and the other two with their respective marks on the other pulleys. Install the tensioner, rotate the engine two or three times to make ...

...pulley. Remove double clips from pulleys. Turn the crankshaft pulley clockwise by two turns. Measure the rod protrusion to ensure it is within the standard. Standard 4-6 mm (0.16-0.24 in) 13) If out ...

Question about 1993 Rodeo

1 Answer

how to hook the drive belt to the pulley and the motor double the belt above the idler and push the doubled part through the idler and over the motor pulley. Leo Ponder imufo2@sbcglobal.net

double pulley is loose and resultingly tore the serpentine belt. What part do I need to keep the double pulley on the crankshaft? looks like the nearby one has a plate with a locknut. pulley should be

a bad tensioner will cause this problem. the alignment will be of a little, it doesnt take much to have belt ride off the pulley, take a good look and double check pulleys that were replaced. good day

...double pulley is located at the front of the deck near the center. The other two pulleys are located near each side of the deck. Route the belt around the outside -- the side toward the outer edge of ...

double pulley on the back of the deck you might want to check to see if the bearings are bad on the double pulley. If I had the model of the mower it would help, they make different types of 47" decks

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73783 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42221 Answers

john h

Level 3 Expert

29497 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...