Questions & Answers for: dc 400

...400 .1998 first unplug the connector for the startor. then check for power AC on all 3 wires, it has to be the same at 4000 or 5000 rpm. some 50 or 60 volts AC. if this is ok then plug it back and ...

...starter solenoid has a B and an S on it. B goes to the battery and S goes to the starter. Chaz Moto ...

I have a dc code...what is it "dc" code - Machine never exceeded 400 RPM due to an unbalanced load.

400 watt inverter worked fine until recently, when in would no longer power anything. I checked the AC output voltage and am gettting only 25 volts, rather than the 110-120 volt range. Any suggestions

dc adapter to charge Husky jump-start 400 amp I just need the Ac adapter to charge Husky jump start 400 amp Sure, you can find it on amazon... here: Amazon com Husky jump start adapter . I hope I have

...400 error 805 002 i have changed the dc board but still have this problem . when i start the machine then first it shows close the front cover. and after some time e805 Your connector is not good is ...

...400 photocopier machine? DC control position is behind of machine. open plat cover and you ll see lot of electronic. DC control is bigger module (PCB) then the other.and SSR is above of DC. what s ...

...dc 400 language i have fuji xerox dc 400 machine but i dont set display language in english please help me Go through the Menu options until U find Language and chage it to english if thats not ...

Will not read ac or dc amperage Will not read act or DC amperage Check the internal fuse - usually there for amperage readings. There is no internal fuse (it's clamp meter), check for loose 4mm banana

where can I buy a recharge cord and transformer for my jumpstart 400 MK2 450 amp DC Charging Adapter . 12 Volt DC 700 Milliamps or greater. Radio shack has them or you can google charging adapters.