Questions & Answers for: Bernina circut machine Computers & Internet

...need to break that circut if you cant find the working foot pedal maybe you could use a tattoo machine gem footpedal they are breakers fairly cheap online and very manuverable when in tight

Machine will not turn on after being plugged in Machine will not turn on check the power supply then all the wires also pedal the machine as well as connection to the machine if problem still exist ...

machine will only run intermitantly foot control is fine but wont operate this machine it works on other machine are you needing a foot pedal for the machine? or is there another problem with the ...

How do I remove the back panel of my Bernina 1080 sewing machine? The machine slowed to a stop with a whirring sound coming from the back top righthand side. The back panel on the BERNINA 1080 is not ...

What are the tension numbers for a Bernina MO-203 over locker sewing machine? Basic Tips for All Always turn the handwheel TOWARDS you (counter clockwise) as turning it in the opposite direction (away

how do I oil the machine. I have looked in the manual and it doesn't show anything at all on this subject. unless I missed something. There is little to no maintenance on this machine in general. The ...

Repair body of my machine I dropped my bernina 430 machine which resulted in the carrying arm of the machine being jammed into the machine. The machine works but the arm will not move and the top of ...

How do I open top part of my sewing machine While sewing, the machine just stopped. When started it was not very smooth, it was bit hard I thought. How to fix this problem. Electricity connection is ...

My bernina sewing machine dealer has gone out of business. I need a source of oil for my Bernina 780 and clip for the stitch plate for my 630. any sewing machine oil will do the job parts can be ...

I bought a bernina 180 embroidery unit and attached it to my machine. It is a 4 pin that plugs into machine . It has ACN003227629 on both the machine and unit but machine not recognizing it? Requires ...