channel.accept(); client.configureBlocking(false); client.register(selector, SelectionKey.OP_READ); }else if(key.isReadable()){ SocketChannel channel = (SocketChannel) key.channel(); if(channel.socket
channel selector for Cobra 200 GTL The channel selector was kinda bend a little bit. When you turn a full 360 turn you feel some resistant. I continue using the radio for a while, into it LOCK UP in ...
Question about Radio TK 260 360 270 370 2100 3100 Compatible Battery
selector to channel 8. Look back time A Turn selector to time in seconds 9. Look back time B Turn selector to time in seconds 10. Revert Channel 1 = Selected 2 = Last Call 3 = Last used 4 = Selected +
selector to channel 8. Look back time A Turn selector to time in seconds 9. Look back time B Turn selector to time in seconds 10. Revert Channel 1 = Selected 2 = Last Call 3 = Last used 4 = Selected +
...channel selector knob on channel 2, If the recieve comes back or goes on and off, the channel selector may need to be cleaned or it might have what is called a cold solder joint. Any radio that has ...
Channel. It is a tuner selector problem, either the processor controller ic is the problem, or the selector ic. The easiest solution use a VCR as your channel changer, and check to make the VCR is set
channel selector through all settings a couple of times. This will give some indication of the real problem. If the channel comes back after exercising the channel selector, then you have a "Furred up
...SELECTOR CHANNEL THAT IS NOT DAMAGED CHECK THE CABLE CONNECTOR COAXIAL. AGAIN MAKE CHANNEL SCAN., BUT GET NO TUNE CHANNEL. SURE THAT OTHER VIDEO INPUTS., HDMI & USB OPERATING NORMALLY, IF THIS IS ...
channel selector only works going down not up cb radio there is two common connections to the channel selector up and down resolder the channel sectors pins then it will work its a broken connection ...
Question about DeltaForce CB Radio
...channel stereo speaker selector that allows you to connect up to four different stereo speaker sets. It can handle up to 100 watts per channel with speaker systems that have a minimum impedance of 8 ...
Usually answered in minutes!
19,136 Questions
12,215 Questions
7,310 Questions
7,276 Questions
5,470 Questions