Questions & Answers for: chainsaw surges

I have a 36cc poulan chainsaw and it runs but not very good when u hold wide open or just a little it sounds like it surging I would go to Poulanpro.com with your model number and take a look at the ...

i bought a cordless lawnmower at auction but unsure how to get it to work Does the blade turn by hand? If so, then the motor bearings are ok. The motor uses brushes as part of the electrical ...

Chainsaw stalls in horizontal position Poulon Pro 260 Chainsaw stalls when cutting with blade held horizontally, e.g. when trying to cut off stump of small (4-6 inch) treeclose to ground. Inside the ...

...Chainsaw.Erratic running Saw starts well, but when I try to accelerate the engine ''surges'' and will not reach high revs Check the fuel filter, air cleaner and muffler for plugging. Warm up the ...

...chainsaw when it starts and runs it surges and runs out of control. what would cause this? ken this may be dumb but, have you cleaned your air filter? check that first. then recheck your needle ...

034 stihl chainsaw will not power under load starts surging Hi, Carberater Jets are/or partly clogged. Disassemble and clean Goodluck.

Homelite 150 automatic, engine surges and dies If you have already replaced the fuel filter in the tank, then your next option would be the small filter screen located inside the carburetor.

engine runs fine then starts to surge Carburetor not set properly. Check fuel filter and air filter.

how do you adjust the governor on a kawasaki 22.0 v twin it will run with the choke pulled open but it surges with the choke off Found a forum on your governor. Kawasaki twin Governor adjustment

...chainsaw surges. would this be a bad carburetor? RY10520, Even after adjusting the (H) to the lowest setting, readjusted till ran, same results, I increased (H) on carb with no noticeable change in ...