Questions & Answers for: apart laminator

...laminator is jammed and will not un-jam. Can I take it apart? I unscrewed the two screws in the bottom but I cannot tell where it is still connected. my laminator ate the paper inside the laminator ...

...laminator apart. laminator 17466 I need to take my laminator apart. It ate a paper I was laminating (nothing on either side; completely gone). I took the two screws out of the bottom, but still can't ...

laminator is not heating anymore:(. It turns on and after few minutes the red light on the power button starts to blink. If I pass laminating pouch through, it comes out on the other side unlaminated.

...apart to get a pouch out that got stuck and cannot remember where a piece goes. There are two long pieces that look like a grate and I do not remember how the one on the front side goes. If I could ...

How do I get laminating pouch out that has rolled up inside the machine? pull the machine apart and remove the melted plastic from the roller basically laminators are so cheap the it is quicker to ...

...apart. Are you letting the laminator reach operating temperature? If the ready light is on and it is not getting hot then you may have a problem with the temp. sensor. Put your hand near, but not on, ...

My laminator is not working correctly. The lamination is not adhering my materials are falling apart. What could be causing this? Not heating the rollers.

would not try to remove it... it may cause the blades to de-laminate ..or other wise start to "fall apart".. and thats NOT something you want to happen in ceiling fan blades..at high RPM.

I jammed my Saturn 3i95 Fellowes Laminator. I pulled the first project out, but the 2nd one disappeared within the laminator. Now what do I do? Take it apart and retrieve the sheet.

...apart the laminator?? The film wrapped around the top of the very last set of rollers before the film comes out. These are the very last set of rollers I'm talking about. Just before the film comes ...