Questions & Answers for: Behringer amp knobs Audio Players & Recorders

...amp it doesnt work and in the "screen" there's what appears to be an error message "E2". The light above the "Edit" is also on. None of the other knobs and buttons work, and it doesnt produce any ...

...Behringer parts outlet, that might cost some money... or you could build one. You have one in the amp. Copy it. Did you find the replacement for the right side of your EP2500? If so, where did you ...

...only be one side and fairly low volume, usually the left). If it does, then cabling and whatever amp you have for the MON1 has a problem. I have schematics and can help you troubleshoot a bit.

low volume even when vol2 knob is turned fully UP! The user manual is located at: http://www.bugera-amps.com/PDF/Downloads/1960_P0671_M_EN.pdf on page 5; When the HIGH 1 and LOW 1 (or HIGH 2 and LOW 2

...amp; 25. I've been told that the problem has something to do with the power source, but I'm still trying to get a solution. Best luck ! Those are the selected effects that will become active. ...

...amp on without anything plugged and all the knobs down, It still buzzes, any suggestions? thanks Since you just bought this, exercise your warranty (assuming you bought this new). The amp probably ...

...a few times) can help it. Some cleaners can leave behind a residue and make it worse, so ask at an amp repair place what product is best to use. Hope this

...amp; 2 signals. Please provide some suggested resolutions? Is there anything other then the channel monitor level knobs and the main monitor level slides that control this? Try plugging in a set of ...

...select knob the light/number continues to flash and the effect cannot load I have tried turning off amp and turning it on while holding down the select knob with no luck.Can someone please help? Not ...

...checked the speaker leads in the back to make sure they are hooked up> if so, you have power to amp? Volume knob turned up? is guitar cord good? (try it in a different amp , or check w/ an ohm ...