Questions & Answers for: Rowenta amp knobs Irons

Does not steam. No pressure being built up. I believe that it is not sealing tight around the water inlet screw. If I jiggle it then the pressure will sometimes build up. Can I purchase a new sealing ...

...have a Rowenta 1700 iron. The iron has started to act up. When I plug the iron in it just flashes & does not get hot. It is like it is in the stand by mode when you leave it on & don't iron ...

net Thanks in advance! Robert mY de 87.1C WAS WORKING AN ABOUT TWENTY MINUTES OF IRONING, THE CORD & PLUG IN BLEW & IT QUIT

My grandson knocked my Rowena Iron model DE-87.1b My grandson knocked my Rowenta Iron model DE-87.1b off the ironing board and the knob broke off. It works fine but I cannot adjust the temperature. ...

...working yet iron still heats up and light on boiler still goes on. this just happened to us & the electronics man at my husband's plant took it apart & said the thermostat needs ...

...was sediment inside when I moved the iron? Fill the resevoir with a 25% vinegar to water solution & turn on the iron until it steams. Allow to cool and empty resevoir then rinse with clean

my rowenta compact iron handle will not lock in the open position...thanks for any assistance...it's a great little helper There probably is a plastic tip broken on the inside handle. The only cost ...

...breaker after 10 minutes of use This iron is 1500 watts. On a 120 volt breaker, that's about 12.5 amps. Check to see what else is on this breaker. A 1500 watt space heater or a washing machine ...

Leaking water when I push the trigger to get steam It sounds like you do not have the heater setting not high enough to provide vaporize the water in the heater tank. Did you adjust the temperature on

...Well this was helpful but also HELLfull! I guess because I have a 9050 !! I took out the screws & could not remove the hose it was attached with 2 clamps & a washer! I put the whole darn ...