Questions & Answers for: Whirlpool amp knobs Hardware & Accessories

...gas when control knob is turned on? most likely you need the ignitor/glow bar. to test you need a clamp on amp meter to see if you have 3.0 to 3.3 amps, if it glows and doesn't light the ignitor is ...

...moves if Auto Dry is chosen (the knob does move in Timed Dry.) I did remove the front panel plug & can see the heating elements glowing intermittently. The light cycles on & off once (not ...

...out. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE

load size select nob is stuck in small load position & i can't get it to turn the selector knob has finally taken a dump and needs to be replaced the part number you need is gonna be located on ...

...(F4 to F16) (Electrical Problem) Select PAUSE/CANCEL twice to cancel the cycle. Select DRAIN & SPIN if there is excessive water in the washer. Re-select cycle and press START. If the

...store and ask if they sell new or used knobs, but here is a website if you can wait: ...

no codes given control light flashing on selector knob but machine will not start Hello & Welcome to FixYa Your whirlpool duet washer needs a reset to resolve the control lock problem. Press and ...

...cannot turn it. Have removed knob to try to turn the c--shaped thing with a wrench. It wont budge & appears to be cracked. Do these things just die with age? Because it's NOT used

...other cycles Hello Mr. Robertson. With your computer go to 'Sears Parts' and search for your make & model. This site will provide the complete technical service manual including parts ID & ...

...in diameter and only protrudes about 3/8 inch - so difficult to grip. Any suggestions? The control & pump you have is no longer being made. (It hasn't been made for well over 5 years) Your new ...