Questions & Answers for: adf front error

...ADF. (6) Remove the Control Panel Unit. (7) Remove 8 Screws from scanner base (8) Remove the Wire Clamp (9) Remove the Scanner Cover Assembly (10) Disconnect the Harness (11) Remove 2 Screws (12) ...

...adf when there is no paper... no paper pieces and sensor seems to be freeley going up and down is there a way to reset the whole unit or something??? Clean the paper sensors and move the ...

...front door. U5 means the ADF (Automatic Document Feeder) is not sensed. Connect its cable behind the copier if no ADF present, disable by pressing C,Interrupt, O, Interrupt - display will go off. ...

...ADF front side. Fujitsu 5750c s Anomaly in the light intensity of ADF front side lamp. CODE D542037 Hi,  This error code denotes ADF front side scanning optical alarm (lower optical unit ADF) ...

ADF front side scanning optical alarm (lower optical unit ADF) which indicates ADF (front) lamp intensity check. Please follow the steps provided below: 1. Is the upper glass (white sheet guide)of the

front optical unit. is there any solution to set/repair optical unit? Hi Adil,  This E3 error message means ADF backside scanning optical alarm (upper optical unit ADF) which indicates ADF (back)

...adf, specifically the left side one (looking from the front). Inside the hinge there are two springs exerting tremendous force on the hinge (that enables the lid to stay up by itself) however this ...

ADF where the paper is fed. ( small black plastic protrusion )that should should be positioned at the front of its little slot. I think there are 2 sensors so check that they are functioning properly

...front) does not close all the way. Close the adf and look at the gap between the copier and the adf.  The gap should be the same from the front to the back. If the gap is bigger at the rear ( ...

...adf Check the document feeder is it aligned properly. There is a small magnet and sensor magnet on the Document feeder right front sensor under the plastic that side ensure they are aligned. Does ...